-
Nose repair in Goteborg?
Hello,
I need to do a small nose repair on my board, does any know a good workshop where I could have this done in Goteborg area? It is small but need a proper waterproof repair and I never did that before.
Thanks you for your help.
Plettil -
9 Svar
-
@Plettil 734699 wrote:
Hello,
I need to do a small nose repair on my board, does any know a good workshop where I could have this done in Goteborg area? It is small but need a proper waterproof repair and I never did that before.
Thanks you for your help.
PlettilThen it´s about time you did…!!!
http://www.surfzone.se/forum/showthread.php?94757-Hur-laga-detta
check out the film in the tread…. and perhaps this….
http://www.vikingstrand.se/?page_id=100or,,, http://www.boardlady.com/repairmenu.htm
loads of others on Y.T.
but be warned…. it´s a messy job…….don´t do it in your kitchen…..
and use safety gear!!!!
Good luck -
Thank you!!
I am just not equipped with all papers or vacuum bagging stuff and would like to do a nice and clean repair.
Anyone has a vacuum pump and bagging equipment I can borrow so I can at least press it properly? I bought fiber and resin…I need to add microballoon and I can start.
I kept asking in boat stores for a composit workshop and nothing exist in Goteborg….quite surprising for me…..
I will do…. -
No need to vac a repair. Unless it is a major one, like snapped board.
-
Ok, then I will do.
-
go with the poor-mans vacuum……plastic film and tape it hard….
-
Here is a store which sell composites. I am going to buy 2 and perhaps 1 mm airex. Want to share? I live in Askim.
http://www.carbix.se/product.html/airex -
Ps. My board is snapped. DS.
-
Now I have glued my board. I used very little of the ”PU lim”, if you want you can borrow it.
-
Luckily I did not need airex or so. Just a small crack in the nose that was not water tight.
Several layers of glass fiber, film, tape and roller…. The worst is the paint…not the same white….
It will be ok for me until the next….
Tack alla för din hjälp!!
Logga in för att svara.
